How to fix this error? - Solid Modeling

Welcome Guest! To enable all features please Login or Register.

Notification

Error

How to fix this error? - Shelling out after converting to SubD to Nurbs

Options

Previous Topic Next Topic

rockyroad_us		#1 Posted : Tuesday, July 11, 2017 9:22:29 AM(UTC)
Rank: Senior Member Joined: 9/12/2009(UTC) Posts: 608 Location: In my place Was thanked: 59 time(s) in 51 post(s)		Does any one know how to fix this error after converting to NURBS? See pic. This is something I didn't draw from scratch but rather imported from 3D-coat. Something to do with bad curvature. The pop up screen says see err info but how do I find that out. Nothing shows up. Is there a command that I'm not aware to see these err infos to which I can see this error info. I'm trying to shell this out. Will try a smaller value see if I can shell it out at all. rockyroad_us attached the following image(s): error1.jpg (65kb) downloaded 5 time(s). You cannot view/download attachments. Try to login or register.
		FX 7-FXPro14-1650 MacPro 11.7.4 2x2.8GHz Quad Xeon 32GB NVIDIA 4 K5000 4GB Work
		WWW

User Profile View All Posts by User View Thanks

Tim Olson		#2 Posted : Tuesday, July 11, 2017 12:29:29 PM(UTC)
Rank: Senior Member Joined: 2/2/2007(UTC) Posts: 5,447 Was thanked: 502 time(s) in 353 post(s)		Usually this means the shell would self intersect/loop at the specified offset value. Trying a lower value is a good idea. To track down the region preventing the shell, you could split the solid into multiple parts. Tim
		Tim Olson IMSI Design/Encore


User Profile View All Posts by User View Thanks

Guest		#3 Posted : Tuesday, July 11, 2017 1:45:21 PM(UTC)
Rank: Guest Joined: 8/27/2014(UTC) Posts: 394 Was thanked: 13 time(s) in 12 post(s)		Hi Tim, No go on the lower values. Will try splitting into multiple parts and see where it goes. Is there a way to shell a mesh, the same way one does in NURBS before converting? The thing is that this is a scan that someone sent to me and the scan is not hollowed out and I'm trying to hollow it out. No problem with the surfaces after converting to NURBS. It is as if I'm trying to shell out just the body of that Bunny in that video you did but from the bottom plane.

Tim Olson		#4 Posted : Tuesday, July 11, 2017 2:50:10 PM(UTC)
Rank: Senior Member Joined: 2/2/2007(UTC) Posts: 5,447 Was thanked: 502 time(s) in 353 post(s)		>>Is there a way to shell a mesh No sorry. Something I'd like to investigate though. Below is a video of a part that will only shell regionally (around 2:30 mark). Curvature around mouth, eyes, tail prevent entire body from shelling. I then boolean back the splits to create one body again. http://www.csi-concepts.com/Demo/videos/turtle.mp4 Tim
		Tim Olson IMSI Design/Encore


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.